Magpowr DIGITRAC
2 Instruction Manual - Digitrac

DIGITRAC

%%%%

 2 Specifications

Supply Voltage

115 or 230 volts rms, 

10%

Supply Frequency:

50 or 60 cycles per second, sinusoidal

Fuses: F1, F2

1.6 amp, Littelfuse Part No. 21601.6, or

Wickmann Part No. 19194-053-FS

Enclosure

D2

Front Panel

IP65   (IEC529)

Enclosure

IP20   (IEC529)

D2E

IP65   (IEC529)

Climatic Class:

3K3 (EN60721)

Temperature Range:

Operating

0

-C to 40-C

Storage

-30

-C to +80-C

Relative Humidity

5% to 85%

Pollution Degree:

2 (IEC664-1)

Altitude:

0 to 2000 m

Compatible Residual 

Current Devise Types:

A or B (IEC755)

Worst Case Fault Current:

1.6 amp

Inputs:

Tension Sensor

2.1 mvdc using +5 and -5 vdc (10 vdc)

across one 350 ohm sensor or two 350 ohm sensors 

in parallel, or

100 mvdc, using 5 volts across one 100 ohm full bridge,

or

0 to +10 vdc analog

Diameter

0 to +10 vdc analog, or

20 to 10,000 pulses per second, 5 volt TTL

Web Speed

0 to +10 volts analog, or

20 to 10,000 pulses per second, 5 volt TTL

E-Stop

switch closure or 5 vdc or 24 vdc logic

Run/Stop

switch closure or 5 vdc or 24 vdc logic

Tension Off

switch closure or 5 vdc or 24 vdc logic

Format

switch closure or 5 vdc or 24 vdct logic

Outputs:

Torque

0 to +10 vdc., 1 madc maximum

4 to 20 madc, 500 ohms maximum

-10 to +10 vdc, 1 madc maximum

Tension Reference

0 to +5 vdc., 1 madc maximum

20